F&P SleepStyle Product Technical Guide | 71
Clinician Guide – Page 29
A-29
10.4 Replacing the Air Filter
between Patients
The air filter is located at the rear of the device
and ensures the air intake into the device is
filtered to remove particles and dust. The air filter
is not washable and must be replaced between
patients. To replace the air filter, please follow the
instructions below.
Warnings
To avoid choking, or inhalation of a foreign
object:
Do not use the device without the
recommended air filter fitted. This will reduce
dust or particles entering the device and
breathing tube.
1. To remove, pinch the air filter with your fingers
and pull it out of the device.
2. Hold onto the short side of the new air filter.
Push into the device so there are no gaps.
10.5 Deleting Therapy Data
between Patients
For accurate compliance reports, data must be
cleared from the device memory, as well as the
InfoUSB, before use by another patient. Follow the
instructions in section 7.3 – Clear Patient Data to
delete therapy data from the device’s memory.
ENGLISH
To Next Page
Loading...
