F&P SleepStyle Auto - Reassembly of the Device and Accessories

F&P SleepStyle Product Technical Guide | 70
Clinician Guide – Page 28
A-28
10.3 Reassembly of the Device
and Accessories
OUTLET SEAL
Hold the tab on the outlet seal and push it into the
chamber housing inlet. Ensure the tab is sitting flat
against the wall of the chamber housing.
WATER CHAMBER AND CHAMBER SEAL
1. Close the chamber lid. Press the chamber tab
down until it clicks into place.
2. Secure the chamber seal back onto the water
chamber by pushing down in the finger holds.
Ensure it is sitting flat and seals the holes on
the chamber lid.
3. Place the water chamber back into the device.
BREATHING TUBE
1. Hold the elbow end of the breathing tube and
push it into the air outlet of the device.
Note: If you are connecting a new
ThermoSmart breathing tube, make sure the
electrical connectors on the elbow click into
position with the ThermoSmart connection.
2. Holding the mask and the other end of the
breathing tube, push the mask swivel firmly
into the breathing tube.
3. Reconnect the elbow to the standard breathing
tube.
DEVICE
Reconnect the power cord to the rear of the device
and reconnect the power cord to the mains power
supply.
ENGLISH