Fargo DTC1250e - Remove;Replace the PCB Output Controller -A930503

DTC1000Me-1250e-4250e-4500e Card Printer Service Manual PLT-01543 rev 1.0
November 2013 87
.
Remove/Replace the PCB Output Controller -A930503
Step
Procedure
1
Caution: Turn OFF the Printer and unplug the power cord from the Printer.
2
Remove the Flipper Covers.
3
Disconnect all cable connections
4
Hold the 2 tabs BACK to release the board from the holding tabs.
5
Replace with new board.
6
Procedure is complete
Tools needed: T10 Torx screwdriver
Estimated Repair Time: 20 min
Preparation: Remove the Covers
Important: This procedure can only be performed by
authorized service personnel.