Fargo DTC4500 - Page 110

© 2010 HID Global Corporation All rights reserved
DTC4500 Card Printer/Encoder User Guide L001444 Rev1.0
110
Troubleshooting with the Error Message Table
Error Message Cause Solution
#57
Wrong Lam Type
See the next column. Install a new film roll and press
RESUME to continue or
CANCEL to abort. If the
problem persists, call for
technical assistance.
#58
Check Lam Material
See the next column. Install a new Lamination roll and
press RESUME to continue or
CANCEL to abort. If the
problem persists, call for
technical assistance.
#208
#209
No Lam
There is no Laminate installed
or it is broken.
Check the Lamination and try
again
#211
Wrong Lam Type
An incorrect Laminator film has
been installed, or a driver
setting is incorrect.
Install a new film roll and press
RESUME to continue or
CANCEL to abort. If the
problem persists, call for
technical assistance.
#210
Remove Lam
Driver is set for single side
lamination but there are 2 rolls
of laminate in the printer.
Remove the roll not used and
try again.