FaroArm User Guide
January 2007
10
Chapter 1: Introduction to the FaroArm
Error and Status Indicators
Through the software interface to the measuring software, the FaroArm
generates and displays errors.
• The encoder end stop warnings - when an encoder reaches one
end of it’s rotation.
• The tube Stress Stop warnings - when there is stress on one of
the tubes or encoder joints. The Stress Stop warnings may be
disabled. See “Hardware Configuration” on page 30.
• Other errors are displayed in a message box.
N
OTE: The FaroArm does not output data until the error has been
cleared.
Figure 1-6 FaroArm end stop warning
Figure 1-7 FaroArm stress stop warning
08M46E00_FaroArmUSB.book Page 10 Monday, January 15, 2007 1:12 PM
To Next Page
Loading...
