Feig Electronic VEK MNH2-R24-C - Page 53

VEK MNH
Key words
VEK MNH Operating Manual v1.3 en
53 | 56
Positioning of the loops....................................... 53
Power supply ...................................................... 25
Pulse signal ........................................................ 49
Q
Queue ................................................................. 50
R
Relay ................................................................... 26
Relay outputs ...................................................... 26
reset button ................................................... 18, 37
S
Safety Extra-Low Voltage ................................... 25
Sensitivity ............................................................ 40
Service interface ................................................. 38
Service program ................................................. 38
Setting direction detection .................................. 47
Setting direction logic .......................................... 48
Setting hold time ................................................. 43
Setting hysteresis ............................................... 41
Setting loop frequency ........................................ 42
Setting output mode ............................................ 43
Settings ............................................ 18, 35, 37, 40
Short circuit ......................................................... 24
Signal behaviour ................................................. 44
Signal output ....................................................... 26
Signal outputs .............................................. 26, 44
Signal type ......................................................... 43
Single vehicle ..................................................... 49
Status indicators ................................................ 33
Switch........................................................... 35, 44
Switch status ...................................................... 26
Switching time .................................................... 45
Switch-off delay .................................................. 46
Switch-off threshold ........................................... 41
Switch-on delay .................................................. 46
Switch-on threshold ........................................... 40
T
Terminal block .................................................... 18
Top hat rail ......................................................... 29
Traffic Detector .................................................. 18
Travel direction .................................................. 49
U
USB .................................................................... 38
USB connection ................................................. 18
V
Vehicle detection ................................................ 24
W
Wrong-way driver ......................................... 48, 50