KNOWING THE INSTRUMENT PANEL
70
ILLU
SPEEd
Hour
bUZZ
Unit
BAG P (for versions/markets, where
provided)
Selecting a menu option
press the SET button briefly to
select the menu setting you wish to
change;
press the and buttons
(with single presses) to select the new
setting;
press the SET button briefly to
store the new setting and at the same
time go back to the previously selected
menu option.
Selecting “Set Clock”
press the SET button briefly to
select the first value to change (hours);
press the and buttons
(with single presses) to select the new
setting;
press the SET button briefly to
store the new setting and at the same
time go to the next set-up menu option
(minutes);
after setting the values with the same
procedure, go back to the previous
menu item.
Hold the
SET
button pressed
quit the set up menu if you are in the
menu;
quit the displayed menu if you are
setting an option;
save only the changes already stored
by the user (and confirmed by pressing
the SET button).
The set-up menu page is timed. When
the menu is exited due to expiry of the
time allowed, only the changes already
stored by the user (and confirmed by
pressing the SET button briefly) will
be saved.
From the standard screen, press
the SET button briefly to start
browsing.
Press or to browse within the
menu.
Note Only the short menu can be
accessed while the vehicle is moving
for reasons of safety ("SPEEd" setting).
Stop the vehicle to access the full
menu.
Adjusting the vehicle interior
lighting (ILLU)
This function is available with the
dipped beam headlights on to adjust
brightness of the instrument panel,
buttons and radio display.
Proceed as follows to adjust the light
intensity:
press the SET button briefly: the
display will show the wording ILLU;
press button and to set the
required brightness level;
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
Setting a speed limit (SPEEd)
This function is used to set a speed
limit (km/h or mph); the driver is
alerted when this limit is exceeded
(see “Warning lights and messages”
in the "Knowing the instrument panel"
chapter).
To set the desired speed limit, proceed
as follows:
the SET button briefly: the
display will show the wording (SPEED)
and the unit (km/h) or (mph) previously
set;
press or to select speed
limit activation (On) or deactivation (Off);
if the function is On, press or
to select the required speed limit
and then press SET to confirm;
Nota The speed may be set in the
range from 30 to 200 km/h, or from 20
to 125 mph according to the previously
chosen unit (see “Setting the unit of
measurement” below). The setting will
increase/decrease by five units each
time the / button is pressed.
Hold down the / button to
To Next Page
Loading...
