Fiat FIORINO 2021 - Page 73

71
automatically increase/decrease the
setting rapidly.
Complete the adjustment with single
presses of the button when you
approach the desired value.
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
To cancel the setting, proceed as
follows:
briefly press the SET button
briefly to make the display flash (On);
press : (Off) will flash on the
display;
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
Setting the clock (Hour);
With this function, it is possible to set
the time.
To adjust, proceed as follows:
press the SET button briefly:
"hours" starts flashing on the display;
press the or button to
make the adjustment;
briefly press the SET button:
"minutes" starts flashing on the display;
press the or p button to
make the adjustment;
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
Adjusting the buzzer volume (bUZZ)
This function is used to adjust
the volume of the acoustic signal
(buzzer) that sounds in the event of
failure/warning indications and when
the SET , and buttons
are pressed.
To set the desired volume, proceed as
follows:
press the SET button briefly: the
display will show the wording (bUZZ)
- press or to select the
required volume (adjustable over 8
levels).
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
Setting the distance unit (Unit)
This function is used to set the unit of
measurement.
To adjust, proceed as follows:
press the SET button briefly: the
display will show the wording (Unit) and
the previously set unit (km) or (mi);
press or to select the
required unit.
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
Passenger front airbag
and chest-pelvis side bag
activation/deactivation (Bag P) (for
versions/markets, where provided)
This function is used to
activate/deactivate the front passenger
airbag.
Proceed as follows fig. 131:
press the SET button and,
after the message BAG P OFF (to
deactivate) or BAG P On (to activate) is
displayed by pressing buttons or
, press SET again;
a confirmation request message will
appear on the display;
press buttons or
to select (YES) (confirming
activation/deactivation) or (no) (to
abort);
briefly press the SET button: a
message confirming the selection will
be displayed and you will return to the
menu screen or, pressing the button for
longer, you will return to the standard
screen without saving.