KNOWING THE INSTRUMENT PANEL
76
briefly press the SET button to
return to the submenu screen or hold
the button down to return to the main
menu screen without saving;
press the SET button down again
to return to the standard screen or to
the main menu according to where you
are in the menu.
Setting the unit of measurement
This function allows the setting of
a unit of measurement via three
submenus: Distance, Consumption and
Temperature.
To set the desired unit of
measurement, proceed as follows:
briefly press the SET button to
display the three submenus;
press the or button to
navigate through the three submenus;
after you have selected the submenu
to be changed, press the SET
button briefly;
when you enter the "Distance"
submenu, pressing the SET button
briefly makes the display show "km"
or "mi" (depending on the previous
setting);
press or to make your
choice;
when you enter the "Fuel
Consumption" submenu, pressing
the SET button briefly makes the
display show "km/l", "l/ 100km" or
"mpg" (depending on the previous
setting);
If the set distance unit is "km", the
display enables setting of the fuel
consumption unit (km/l or l/100km).
If the set distance unit is "mi", the
display shows the amount of fuel
consumed in "mpg".
press or to make your
choice;
when you enter the "Temperature"
submenu: briefly pressing the SET
button makes the display show "°C"
or "°F" (depending on the previous
setting);
press or to make your
choice;
When you have made the required
settings, press the SET button
briefly to go back to the submenu
screen or hold the button down to go
back to the main menu screen without
saving.
press the SET button down again
to return to the standard screen or to
the main menu according to where you
are in the menu.
Selecting the language (Language)
Messages on the display can be shown
in the following languages: Italian,
German, English, Spanish, French,
Portuguese, Turkish and Dutch.
To set the desired language, proceed
as follows:
briefly press the SET button : the
previously set "language" starts flashing
on the display;
press or to make your
choice;
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
Adjust the failure/warning buzzer
volume (Buzzer Volume)
With this function the volume of the
buzzer which accompanies the display
of any failure/warning can be adjusted
according to 8 levels.
To set the desired volume, proceed as
follows:
briefly press the SET button:
the previously set volume "level" starts
flashing;
press the or button to
make the adjustment;
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
Adjusting the button volume
(Button Vol.)
This function is used to set the volume
of the acoustic signal accompanying
To Next Page
Loading...
