Fiat FIORINO 2021 - Page 79

77
the activation of the SET , and
buttons through 8 levels.
To set the desired volume, proceed as
follows:
briefly press the SET button:
the previously set volume "level" starts
flashing;
press the or button to
make the adjustment;
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
Reactivation of buzzer for S.B.R.
signal (Belt buzzer)
This function can be displayed only
after a Fiat Dealership has deactivated
the SBR system (see "SBR system" in
the "Safety" section).
Scheduled Servicing (Service)
Using this function you can display
information about the mileage intervals
for vehicle servicing.
To consult the information, proceed as
follows:
briefly press the SET button:
the display will show when servicing
is due in km or mi according to the
previous setting (see paragraph "Units
of measurement");
briefly press the SET button to
go back to the menu screen or hold
the button down to go back to the
standard screen.
Note The “Scheduled Servicing Plan”
includes vehicle maintenance at fixed
intervals; refer to the “Maintenance
and care” chapter. The indication of
the "Service" function will appear
automatically, with the key in MAR
position, starting from 2,000 km (or
1,240 mi) and will be displayed every
200 km (or 124 mi).
Below 200 km servicing indications
are more frequent. The display will be
in km or miles according to the unit
of measurement set. When the next
service is close, when the ignition is
turned ON the word "Service" appears
in the display followed by the remaining
number of kilometres/miles.
Go to a Fiat Dealership, where the
"Scheduled Service Plan" operations
will be performed and the message will
be reset.
Passenger front airbag
and chest-pelvis side bag
activation/deactivation
(for versions/markets, where provided)
This function allows the passenger side
airbag to be activated/deactivated.
Proceed as follows:
press the SET button and, after
the display shows the Bag pass:
Off) (to deactivate) or the message
(Passenger Bag: On) (to activate) by
pressing or , press the SET
button once again);
a confirmation request message will
appear on the display;
use the or menu buttons
to select (Yes) (to confirm the
activation/deactivation) or (No) (to
cancel);
briefly press the SET button: a
message confirming the selection will
be displayed and you will return to the
menu screen or, pressing the button for
longer, you will return to the standard
screen without saving.
Exit Menu
This is the last function that closes the
cycle of settings listed in the menu
screen.
Press the SET button briefly to
go back to the display to the standard
screen without saving.
Press to return to the first menu
option (Speed Beep).