Fidelity Electronics 19eA - Page 15

 ** 15 times per second
 30 times per second. Recommended maximum resolution = 30,000 division
 60 times per second. Recommended maximum resolution = 15,000 division
 120 times per second. Recommended maximum resolution = 7,500 division
Note: - After conversion speed is changed, instrument will automatic restart.
F11
Auxiliary Function
 Cnt (Counting) On / ** Off
 AtM (Action Tare Memory) On / ** Off
 PEK (Peak) On / ** Off
 Ani (Animal) On / ** Off
 PCd (Quick Access to Customer & Product Code Setting) On / ** Off
F12
Auto Tare Function
** OFF
ON
Contin
Notes: -
 Off = Auto Tare Function disable.
 On = Only the first table weight applied will be tare off. Minimum tare load ≥ 2d.
 Contin = All stable weight applied will be tare off. Minimum tare load ≥ 10d.
 If Contin is set, select also d.t. (delay time, 0.0 ~ 9.9 second. Default = 0.5 second). Delay time is the time duration from when a stable weight is detected until it is automatically
tare off.
 Enter the preferred d.t. value through numeric keys and then press [Print/M+] to save.
F13
Repetitive Tare Function
OFF
** ON
If F12 is set = Contin, Repetitive Tare setting “Off” will be surpassed.
F14
Buzzer
Kb (keypad buzzer)
(**On/Off)
St (System buzzer)
(**On/Off)
F15
Check Result Buzzer/Light Bar Format
OFF
** IN
OUT
Hi
Lo
Setting procedures: -
1. Set Check Result Buzzer then press [Print/M+].
2. Set Light Bar Format then press [Print/M+].
3. Set Action on Negative Value.
Check Result Buzzer
 oFF = Check Buzzer disabled,
 IN = Check Buzzer activates when reading is within range.
 ouT = Check Buzzer activates when reading is out of range.
 Hi = Check Buzzer activates when reading more than Hi limit.
 Lo = Check Buzzer activates when reading lower than Lo limit.