Quadnet Control Panel Engineering and Commissioning Manual
Continuous
A monitored output programmed to operate as a Fire
Output is in the fault state.
A monitored output programmed to operate as a Fire
Output has been disabled.
The system Day / Night mode timing has been
overridden, and forced into the less sensitive day
mode.
The system has gone in the less sensitive day mode
as programmed.
The pre programmed service interval has expired
and a routine maintenance check is due.
A device programmed as Technical Alarm is in the
alarm state and sending a Technical Alarm signal to
the panel. No indication of a Technical Alarm is given
on the display.
A smoke detector is in the alarm confirmation state,
awaiting confirmation or reset.
An action has been started which utilises a
programmed delay.
Continuous
The alarm sounders have been activated from the
Sound Alarms button on the panel.
The alarm sounders have been silenced whilst
operating, and the system is awaiting a reset.
The control panel buzzer has been silenced whilst
operating and will stay silenced until another fault or
relevant action occurs.
The control panel buzzer has been disabled at
Access Level 3 (Engineer), and will remain silent
until it is reinstated. However, the buzzer will still
operate in the fire alarm state.
To Next Page
Loading...
