Quadnet Control Panel Engineering and Commissioning Manual
FIRE ALARM SYSTEM NOTICE
To Enable the Control Panel Keys
The user controls are accessed from Access Level 2 (User) which is reached as follows:
Enter your access code, eg 1234, followed by enter, or insert the key and turn it clockwise.
The Enable Controls light will switch on, you are now in Access Level 2 (User) and you may
proceed to silence and reset the system.
To prevent unauthorised operation the controls should be kept disabled and the code / key kept secure
under the control of the responsible person
To Manually Operate the Fire Alarm Sounders
To sound the alarms press the SOUND ALARMS button at Access Level 2 (User) as above.
Following a Detector or Manual Call Point Operation
The FIRE LED will illuminate, the fire alarm sounders and the internal panel buzzer will operate as
programmed. Take appropriate action as defined by the emergency plan for the premises.
To silence the alarms press the SILENCE ALARMS button at Access Level 2 (User) as above, then
establish the cause of the alarm and enter the details in the log book.
Reset any Manual Call Points which may have been operated, or if a detector has been operated be sure
that the cause of the alarm has been removed, before resetting the system by pressing the RESET
SYSTEM] button at Access Level 2 (User) as above.
Following a Fault Condition
The appropriate fault LEDs will illuminate. The internal panel buzzer will sound. To mute the internal panel
buzzer, press the SILENCE BUZZER button at Access Level 2 (User) as above. Investigate and rectify the
appropriate fault (competent persons).
To Test the Indication LEDs
Select the Test Display prompt with the UP / DOWN keys, then press ENTER at Access Level 2 (User).
To Disable the Control Panel Keys
When finished with the controls above, press the ESC button, or turn the key off and remove it. The
system will return to Access level 1 (Normal)
The controls enabled light will have switched off and the controls will be disabled.
Important Notes
It is a requirement of the Workplace Regulations that your Fire Alarm System must be regularly serviced
by competent persons.
CONTROL PANEL INSTRUCTION NOTICE
FIRE ALARM COMPANY: _________________________________________________________________________
ADDRESS:
_____________________________________________________________________________________
For service phone: ___________________ (Working hours) ____________________ (Out of working hours)
To Next Page
Loading...
