Fike Quadnet - Power Supply Unit; System Version Compatibility; OSP Version Compatibility

Quadnet Control Panel Engineering and Commissioning Manual
61
Power Supply Unit
See the Quadnet Power Supply Unit Manual for technical details.
System Version Compatibility
The following table explains the compatibility of the various versions of the Duonet system:
CONTROL PANEL VERSION
V1.00 V2.00 V3.00
DEVICES
Multipoint
V1.00
V2.00
V3.00
Multipoint with sounder
V1.00
V2.00
V3.00
Manual Call Point
V1.00
V2.00
V3.00
Manual Call Point with sounder
V1.00
V2.00
V3.00
Sounder / Soundpoint / Hipoint / Bell
V1.00
V2.00
V3.00
Flashpoint / Sounder Strobe / Strobe
V1.00
V2.00
V3.00
Multipoint I/O Interface Module
V1.00
V2.00
V3.00
Loop Powered I/O Module
V1.00
V2.00
V3.00
Conventional Zone Interface Module
V1.00
V2.00
V3.00
FEATURES
Zonal Cause & Effect
V1.00
V2.00
V3.00
Point to point Cause & Effect
V2.00
V3.00
Alarm Confirmation - Local Device warning
V1.00
V2.00
V3.00
Alarm Confirmation - Zonal Warning
V1.00
V2.00
V3.00
Alarm Confirmation - Display Option
V1.00
V2.00
V3.00
Alarm Confirmation – Zonal Linkage
V1.00
V2.00
V3.00
1-4 loop plug on expansion
V1.00
V2.00
V3.00
Network
V1.00
V2.00
V3.00
Site Upgradeable firmware
V1.00
V2.00
V3.00
View / Edit full device attributes at control panel
V1.00
V2.00
V3.00
OSP Version Compatibility
The following table explains the compatibility of the various versions of the Duonet system:
RECOMMENDED OSP VERSION
V0.367
V2.04 V3.02
PANEL VERSION
Panel Versions up to v1.29
√
Panel Versions v1.34 to v2.xx
√
Panel Versions v3.xx
√
NOTE: It is imperative that the correct version of OSP is used to match your version of Quadnet
control panel. The use of an incompatible version may result in incorrect operation of the
control panel. In particular, do not use a V2.xx series OSP with a V3.xx series control
panel and do not use a V3.xx series OSP with a V2.xx series control panel.