Fike Quadnet - Access Level 3 (Engineer)

Quadnet Control Panel Engineering and Commissioning Manual
34
7. Engineer Controls
1. Loop Controls
1. Stop Loop
2. Fast Init: Restart an Unmodified Loop
3. Std Init: Autolearn Loop & Re-address
4. Get Configuration from Devices
5. Re Configure Devices
2. View / Edit Attributes
1. Device
2. Control Panel
3. Zone
5. Aux I/O
3. Direct Commands
1. Find Device
1. Change Codes
2. Loop Card Version
4. Panel ID
3. Panel Serial No.
5. Panel Mode
6. View No of Devices Programmed
7. View No Devices Last Initialised
1. View Logs
1. Current Warnings
3. By Device Type
4. By Loop No - Device No
1. All Events
2. By Event Type
1. User Action
2. Panel Event
3. Fire Event
4. Fault Event
1. Multipoint with sounder
2. Multipoint
5. By Date
2. Current Faults
3. Current Disablements
4. Current Tests
5. Event Logs
3. Disable / Enable
1. Detection Zone
2. Device
3. Sounders
4. Fire Outputs
5. Fault Outputs
4. Set Time & Date
5. Test Modes
6. Day / Night Mode
1. Silent Test
2. Local Audible Test
1. Override into Day Mode
2. Override into Night Mode
3. End all Overrides
3. System Test
4. View Day / Night settings
3. Manual Call Point with sounder
5. Sounders & Strobes
4. Manual Call Point
6. Input / Output Modules
7. Conventional Zone Module
6. Network Events
1. All Events
2. By Event Type
3. By Panel
4. By Date
2. Test Display
4. Network
4. Loops
5. Printer
6. Clear OSP Labels
6. Enable Buzzer Beep on Keypress
6. Default to All Enabled
Access Level 3 (Engineer): Controls Enabled LED flashing quickly
At Access Level 3 (Engineer), the main Fire Alarm Controls are enabled, and the following System
Controls are accessible: