TWINFLEX
®
pro² Control Panel Engineering and Commissioning Manual
45
This active control will allow the engineer to view the version of panel
operating software implemented.
This active control will allow the engineer to view or change the panel
ID Number. This is the number that identifies the panel on the network.
Use the UP and DOWN keys to move the cursor between options and
the alphanumeric keypad to enter the new ID Number.
Please Note: Panel networking functions are not currently
available.
This active control will allow the engineer to view or change the panel
description. This is the name that identifies the panel on the network.
Use the LEFT and RIGHT keys to move the cursor. To change the
text, highlight the character to be changed and use the alphanumeric
keypad to change that character. After changing a character, the
cursor will automatically move to the next position. To confirm the
changes press ENTER to accept the new description.
Please Note: Panel networking functions are not currently
available.
This active control will allow the engineer to enable or disable the
weekly test timer. Use the LEFT AND RIGHT keys to toggle between
the following options. To confirm the changes press ENTER.
1. ON – Once a week at a determined day and
time the routine service light will
illuminate and the fault buzzer will
sound to remind the user to perform
their weekly test. The user will need to
enter the user code or turn the key
and reset the panel to clear.
2. OFF – Weekly test timer is switched off.
This active control will allow the engineer to view or change the day of
the week on which the weekly test will be indicated. Use the UP and
DOWN keys to toggle between the days of the week. To confirm the
changes press ENTER.
To Next Page
Loading...
