60
CONTROL PANEL GUIDE AND SYSTEM OPERATION (CONTINUED)
OPTIONS SCREEN - REGENERATION (CONTINUED)
RECOVERY REGENERATION
If Recovery Regeneration is not performed within the allowed 10 hours, the engine will go into
Limp Home Mode and a DTC will be displayed. There are only two ways out of Limp Home Mode,
perform a Recovery Regeneration or perform a SF exchange at a Yanmar certified service center.
The operator should immediately attempt the Recovery Regeneration by performing the following
operation.
1. Move the machine to a well-ventilated and safe location.
2. Press REGEN softkey.
3. Press the HYDRAULIC INTERLOCK softkey.
4. Press the MANUAL REGEN softkey.
Note: Stationary Regeneration will not begin if any of the following conditions are present:
Coolant temperature is less than 60° C (140° F)
The engine has not been running for 15 minutes
An important DTC is active
If the hydraulic system is on
Idle speed is too high
If these conditions are present, a notification will be displayed. Once these conditions are
corrected by the operator, acknowledge the message and Stationary Regeneration will begin.
To Next Page
Loading...
