65
THE MATERIAL-FEED SYSTEM (CONTINUED)
RADIO REMOTE TRANSMITTER
This Material Blower is equipped with a HBC Radio Remote Transmitter to control the MATERIAL
START/STOP, the FLOOR (speed) INCREASE/DECREASE, and the ENGINE (RPM)
INCREASE/DECREASE. It also contains an Emergency Stop (e-stop) button that will shut down
the engine.
To turn on the Radio Remote, pull out the red machine stop button to release it to its UP position.
To utilize the Material Feed Start/Stop feature of the radio remote transmitter, the initial start must
occur at the point in the initial startup at the control panel. Turn the radio remote on.
Turn the ignition key clockwise to the START position. The key will return to RUN position during
operation once released. Press the power button again on radio remote to enable radio remote
functionality.
The MATERIAL INCREASE/DECREASE function on the radio remote transmitter can be used to
change the floor speed and effectively adjust the output of mulch from the machine.
For additional information, see Control Guide section.
To Next Page
Loading...
