– 75 –
Press
✱
62 AC LOSS REPORT CODE
Reports with Subscriber No. Timing of this report is random with
up to a 48-minute delay. The Restore report has a random delay
of up to about 12 minutes. If AC restores before the report goes
out, there is no AC restore report.
Press
✱
63 LOW BAT REPORT CODE
This will be sent when a low battery condition exists in the
system’s standby battery.
Note: Connection to the standby battery is checked every 3
minutes (CSFM requirement).
Press
✱
64 TEST REPORT CODE
This is sent periodically to test that the communicator and phone
lines are operational (frequency of report is selected in field
✱
51).
Press
✱
65 OPEN/EXIT ALARM REPORT CODE
This is sent upon disarming of the system. 2nd digit = User No., if
expanded or 4+2 reporting is selected.
Press
✱
66 ARM AWAY/STAY REPORT CODES
This option allows for independent programming of AWAY and
STAY reports . 2nd digit of Report is User No., if expanded or 4+2
reporting is selected.
Press
✱
67 RF XMTR. LOW BATTERY REPORT CODE
This is sent in the event that a wireless transmitter low battery
condition exists.
Press
✱
68 CANCEL REPORT CODE
This is sent upon disarming of the system after an alarm condition
was reported.
Press
✱
70 ALARM RESTORE REPORT CODE, 1st DIGIT
This is sent when the zone that caused an alarm is restored to its
non-faulted condition. 2nd digit is automatically sent as the 2nd
digit of the zone alarm report code programmed in field
✱
56, if
expanded or 4+2 reporting is selected.
Press
✱
71 TROUBLE RESTORE REPORT CODE
This is sent when a trouble in a zone is restored.
Press
✱
72 BYPASS RESTORE REPORT CODE
This is sent when a zone that has been bypassed is un-
bypassed.
Press
✱
73 AC RESTORE REPORT CODE
This is sent when AC power has been restored after an AC power
outage.
Press
✱
74 LOW BAT RESTORE REPORT CODE
This is sent when a system low battery condition is restored to
normal.
Press
✱
75 RF XMTR. LOW BATTERY RESTORE CODE
This is sent when a transmitter that previously sent in a low
battery message has sent a message indicating it no longer has a
low battery condition.
Press
✱
92 NUMBER OF REPORTS IN ARMED PERIOD
This option can be used to limit the number of messages (alarm &
alarm restore reports) sent to the central station in an armed
period. “0” limits reports to a total of 10; “1” allows an unlimited
number of reports.
To Next Page
