Fisher FIELDVUE DVC2000 User Manual

Instruction Manual
D103176X012
Viewing Device Variables and Diagnostics
June 2017
37
D Operational Status—This menu item indicates the status of the Operational items listed below. The status of more
than one operational may be indicated. If more than one Operational status is set, they will appear on the display
one at a time in the order listed below.
1. Out of Service
2. Auto Calibration in Progress
3. Input Char Selected
4. Custom Char Selected
5. Diagnostic in Progress
6. Calibration in Progress
7. Set Point Filter Active

Fisher FIELDVUE DVC2000 Specifications

General

Manufacturer	Fisher
Category	Controller
Device Type	Digital Valve Controller
Communication Protocol	HART
Input Signal	4-20 mA
Enclosure Rating	NEMA 4X, IP66
Operating Temperature	-40 to 85°C (-40 to 185°F)
Material	Aluminum
Power Supply	Loop Powered
Diagnostics	Advanced diagnostics
Output Signal	4-20 mA
Certifications	ATEX, IECEx, CSA, FM
Mounting	Integral mounting to actuator

Summary

Section 1 Introduction and Specifications

Installation and Setup Guide

Guide to installation, electrical/pneumatic connections, and basic setup/calibration.

Instrument Description and Specs

Section 2 Detailed Configuration and Calibration

HART Communication and Detailed Setup

Covers detailed setup, HART communication, and instrument modes.

Response, Tuning, and Calibration

Addresses setting response, tuning, input characteristics, and calibration procedures.

Alerts, Diagnostics, and Settings

Section 3 Viewing Device Variables and Diagnostics

Section 4 Maintenance and Troubleshooting

Instrument Maintenance Procedures

Covers stroking, replacing components like I/P converter and pneumatic relay.

Troubleshooting and Support

Guides on identifying symptoms, checking parameters, and technical support.

Appendix A Principle of Operation

Appendix B Local Interface and Menu Trees

Local Interface Flow Chart

Field Communicator Navigation