Flashforge Corporation
Dreamer User Guide | www.flashforge.com
② Auto Suppor ts
Click the [Auto Suppor ts] button, the software will judge the position where supports
are needed and generate corresponding treelike or linear supports. If it is a model with
supports, the existing supports will be deleted and new supports will be generated.
Supports will be added once clicking the [Add] button. Move the cursor to the
position where supports needed, left-click to choose the starting point of supports,
hold down the left mouse button and drag the mouse, the supports preview will show
up (if support surface doesn’t need support or the support column angle is too large,
the support review will be highlighted).Loosen the left mouse button, if support
column doesn’t meet with model, then support will be generated on origin and
terminal point (the highlighted preview support won’t generate support structure)
④ Clear Suppor ts
Click [Clear Suppor ts], all supports will be deleted. The operation can be repealed
via clicking [Undo] or pressing the shortcut key Ctrl+Z.
⑤ Delete Suppor ts
Supports will be deleted once clicking the [Delete] button. Move the cursor to the
To Next Page
Loading...
