Flashforge Corporation
Dreamer User Guide | www.flashforge.com
⑨ More options: Click [Mor e options] to set for layer, shell, infill, speed and
temperature. Different resolution solution is corresponding to different defaults, click
[Restore Defaults] to back to default setting.
a. Layer : Layer thickness of the printing model. With a small value, the surface
of the model will be smoother.
b. Fir st Layer Height: This is the first layer of the model, which will affect the
sticking performance between the model and platform. Maximum is 0.4mm, usually
c. Shell: Contains the outside shell value, capping layer value (under vase pattern,
top solid layer setting is invalid.)
● Per imeter Shells: Maximum is 10
a. Top Solid Layer: Maximum is 30, minimum is 1.
b. Bottom Solid Layer: Maximum is 30, minimum is 1.
a. Fill Density means fill rate.
b. Fill Patter n is the pattern of filling shape which effects printing duration.
c. Combine Infill: You can select the layers for combining according to the
layer thickness. The combined thickness should not exceed 0.4mm. “Every N layers”
is for all the infills while “Every N inner layers” is only for inner infills, which
generally can save print time.
6-14
To Next Page
Loading...
