Flashforge Corporation
Dreamer User Guide | www.flashforge.com
To clean up the recorded operating steps so as to release the memory.
④ Select All
By the following two methods, you could select all models in the scene.(When
models are too small to be seen or out of viewing scope, please click [Center] and
[Scale] buttons to adjust the model.)
Method 1: Click [Edit]--[Select All].
Method 2: Press the shortcut Ctrl+A.
⑤ Duplicate
Select the object and duplicate the object through the following two methods:
Method 1: Click [Edit]--[Duplicate]
Method 2: Press the shortcut Ctrl+D
Select the object and delete the object through the following two methods:
Method 1: Click [Edit]--[Delete]
Method 2: Press the shortcut Delete
⑦ Auto Layout All
Click [Edit]--[Auto Layout All] after loading one or more than one models, all
models will be placed automatically as automatic placement rule.
Click [Edit]--[Repair Models] to repair models.
Click [Edit]--[Supports] to enter supports setting interface.
You can connect the Dreamer with your PC via a USB cable or WiFi.
To Next Page
Loading...
