Flashforge Corporation
Dreamer User Guide | www.flashforge.com
Note: The machine icon on the bottom right displays the connection status:
Method 1：Connect Via USB Cable
a. Connect your Dreamer with your PC via an USB cable.
b. Turn on your Dreamer and start FlashPrint.
c. Click [Pr int]--[Connect Machine], then select USB in the [Connection Mode]
option and select machine you want to connect in [Select Machine] option. If you can
not find your machine, click the [Rescan] button to scan your machine and select it.
Finally click [Connect] button to connect to the printer. If you still can not find your
machine after rescan, it means you haven’t installed the driver in the software.
6-20
Method 2： Connect Via WiFi--AP mode
1. Turn on Dreamer.
2. Turn on Wi-Fi on the Dreamer. Tap [Tools]-[Setting]-[WiFi]-[WiFi ON].
3. A network called “USR-WiFi232-G2” can be found on the list of available
networks. Connect to this network.
To Next Page
Loading...
