Flashforge Corporation
Dreamer User Guide | www.flashforge.com
4.Open FlashPrint, click[Print]--[Connect Machine]. Under “Connection Mode”,
select Wi-Fi, and enter the “IP Address” as shown on printer touch screen. Then,
click [Connect].
5. If successfully connected, you will see the following red mark.
Method 3： Connect Via WiFi--STA mode
1. Turn on Dreamer.
2. Turn on Wi-Fi on the Dreamer. Tap [Tools]-[Setting]-[WiFi]-[WiFi ON].
4. A connection called “USR-WiFi232-G2” can be found on the list of available
networks. Connect to this network.
5. Open your Internet browser. Type in “10.10.100.254” and hit [Enter] on your
keyboard. Enter the username and password to login. The default username and
password are both “admin” The control panel will appear after a successful login.
5. Click on [Work Mode] and choose “AP+STA mode” and save it.
To Next Page
Loading...
