Flashforge DREAMER - WiFi Connection Modes; Method 3: Connect Via WiFi-STA mode

Flashforge Corporation
Dreamer User Guide | www.flashforge.com
49
!Notice: In STA mode, there may be the risk that Dreamer couldn’t be connected via
WiFi forever, if STA mode is set in error.
6. Click on [STA Setting], enter the corresponding password, save the information
and restart to take effect. Your PC connect the network, which was registed.
7. Open FlashPrint, click[Print]--[Connect Machine]. Under “Connection Mode”,
select Wi-Fi, and enter the “IP Address” as shown on printer touch screen. Then,
click [Connect].
8. If successfully connected, you will see the following red mark.
Disconnect Dr eamer
Click [Pr int]--[Disconnect] to disconnect your PC and Dreamer.
6.2.14 Tool Menus
①Control Panel
6-22