Flashforge DREAMER - Control Panel Overview; • Jog Controls

Flashforge Corporation
Dreamer User Guide | www.flashforge.com
50
After connecting PC with Dreamer, click [Tools]--[Control Panel] to open the
control panel.
6-23
● J og Controls
a. Jog Mode：Select the distance that extruder/build plate move a single time (that is,
the distance extruder/build plate move upon your single click).
b. Six blue ar row dir ection buttons: Control the move along X/Y/Z axis. X/Y axis
button control extruder move, Z axis button control build plate move. Click X-,
extruder will move leftward a specified distance; Click X+, extruder will move a
specified distance rightward. Click Y-, extruder will move forward a specified
distance; Click Y-, extruder will move backward a specified distance. Click Z-, build
plate will move upward a specified distance; Click Z-, build plate will move
downward a specified distance. (Specified distance refers to the move distance you set
in Jog Mode.
c. Stop: Click the [Stop] button to abort the current movement.
d. XYZ coor dinate fr ame on the r ight side: Show the current position of
extruder/build plate.
e. Make Curr ent Position Zero button: Set the current position of the extruder/build
1
2
3
4
5
6