FLENDER ARPEX - Page 7

7
ARPEX 8706 en
Operating instructions 10/2017
6.9 Alignment 39..........................................................................
6.9.1 Aligning with distance bush 39...........................................................
6.9.2 Aligning with threaded bush 41..........................................................
6.10 Test run of the customer’s shaft with weight simulators 42...................................
6.10.1 Definition of weight simulators for the test run 42...........................................
6.10.2 Fastening of coupling modules for the test run 43...........................................
6.10.3 Test run of fitted coupling parts with dummy flange 44.......................................
6.10.4 Test run of fitted dummies 46............................................................
6.11 Demounting the intermediate unit 48......................................................
6.11.1 Procedure applying to modules with distance bush 48.......................................
6.11.2 Procedure applying to modules with threaded bush 50......................................
6.11.3 Demounting the fitted coupling modules or components 52..................................
7. Startup 53...........................................................
7.1 Procedure before startup 53............................................................
8. Operation 55.........................................................
8.1 General operating data 55..............................................................
9. Faults, causes and remedy 56.........................................
9.1 General 56............................................................................
9.2 Possible faults 58......................................................................
9.3 Incorrect use 59.......................................................................
9.3.1 Possible faults when selecting the coupling and/or coupling size 59...........................
9.3.2 Possible faults when fitting the coupling 60................................................
9.3.3 Possible faults in the maintenance of the plant 60...........................................
10. Maintenance and repair 61............................................
10.1 General 61............................................................................
10.2 Replacing plate packs 61...............................................................
10.3 Replacing screw connections of the flanges 61.............................................
11. Spare parts, customerservice 62......................................
11.1 Spareparts and customerservice addresses 62...........................................
12. Declarations 63.......................................................
12.1 EU declaration of conformity 63..........................................................