FLENDER ARPEX - Aligning with Threaded Bush

41
ARPEX 8706 en
Operating instructions 10/2017
6.9.2 Aligning with threaded bush
Observe the safety instructions in section 6.1, "General information on fitting"!
In the case of subassembly “X” with threaded bush either distance "S2" between the opposed
subassemblies or dimension "S3" inside subassembly "X" can be measured. The dimensions are taken
at several measuring points "M". The permissible values of "S2" and "S3" are given in the table "Fitting
data" on the orderspecific drawing of the coupling.
For measuring dimension "S2" the fastening must have been fitted. The design of the fastening is shown
on the orderspecific drawing of the coupling.
S2
max
.
S2
min.
M
XVX
M
M
M
M
M
Fig. 35: Measuring point "S2" with the XVX module
M Measuring point
Dimension "S3" is measured with the intermediate unit fitted. For measuring dimension "S3" the fastening
must be removed. The design of the fastening is shown on the orderspecific drawing of the coupling.
Unscrew and remove collar bolt and threaded bush (see figure 36).
Fig. 36: Removing the fastening in case of threaded bush
S3
max
.
S3
min.
M
M
M
M
M
M
Detail "Y"
Detail "Z"
"Z"
"Y"
XVX
Fig. 37: Measuring point "S3" with the XVX module
M Measuring point