B Technical Data FLUXUS G60x
UMFLUXUS_G6V4-2EN, 2011-03-29 219
A Technical Data
Damping Mats (Optional)
Damping mats will be used for the gas measurement to reduce noise influences on the
measurement.
Transducer damping mats will be installed below the transducers.
Pipe damping mats will be installed at reflection points, e.g. flange, welding.
Selection of Damping Mats
type description outer pipe
diameter
dimensions
l x b x h
transducer
frequency
tempera-
ture
remark
mm mm G H K M P °C
transducer damping mat
D for temporary in-
stallation (multiple
use), fixed with
coupling compound
< 80 450 x 115 x 0.5 - - - x x -25...+60
80 900 x 230 x 0.5 - - x x -
900 x 230 x 1.3 x x - - -
pipe damping mat
A for temporary in-
stallation (multiple
use), fixed with
coupling compound
< 300 300 x 100 x 0.5xxxxx-25...+60 for num-
ber of
pieces
see ta-
ble
below
B self-adhesive 300 l x 100 x 0.9 x x xxx-35...+50 l - see
table
below
b
l
D
transducer damping mat
pipe damping mat
reflection mode
diagonal mode
D - outer pipe diameter
To Next Page
Loading...
