Programming the camera
19
19.1 General
You can program the camera to save images periodically.
19.2 Procedure
Follow this procedure to make the camera save images periodically:
1. Turn the mode wheel to
. This will display the following dialog box:
2. Move the joystick up/down to select Setup.
3. Push the joystick. This will display the following dialog box:
4. Push the joystick.
5. Use the joystick to set the following:
• The type of images to save (IR image, Digital photo, IR and digital).
• The time period between which the camera will save an image (hours, minutes,
seconds).
• The stop condition (timer, counter, manual)
• The timer or counter settings, if you selected one of these as stop condition.
6. Push the
button.
7. Move the joystick up/down to select Start.
8. Push the joystick to start the periodic saving.
#T559157; r. AH/45951/45951; en-US
68
To Next Page
Loading...
Need help?
General
