Flowserve Pump Division - 4
Pump Rotation Check
Check rotation by bumping the motor starter for rotation
and viewing the impeller rotation through the discharge.
Confirm that the correct rotation is clockwise when viewed
from above. Y / N
Caution - Stand clear of pump when testing.
Meg OHM Check of Insulation
B-G _______ R-G _______ W-G _______
End User Information
Name
Address
City
State Zip Phone
Operator's Name
Model Number HP
Serial Number
New / Replacement – Replaces Mfr)
Describe Overall Condition of Pump(s) at Start-Up
Pump(s) Storage - No. of Months
Indoors ____ Outdoors ____
Condition of Motor Cable
Were pump ends properly protected? Y / N If not,
explain
Install Pump in Pit
WARNING: Do not use pump power cables to lower pump.
Line Voltage
Power supply line voltage:
B-R ________ R-W ________ W-B ________
Power supply frequency: _________ Hz
See instruction manual if voltage variance exceeds 10%.
Average Pump Running at Rated COS
B ______ Amps R ______ Amps W ______ Amps
List Any Equipment Difficulties During Start-Up
Discharge Elbow and Guide Rail System
Upper guide rail bracket(s) bolted securely: Y / N
Slide rail base(s) properly bolted down: Y / N
Guide rails exactly vertical: Y / N
Base elbow exactly level: Y / N
Debris in bottom of station: Y / N
Liquid being pumped
Final Check
Is pump seated properly: Y / N
Do valves operate properly: Y / N
Nameplate Data
Phase ______ Hz ______ Voltage ______ RPM ______
Capacity _________ Head _________
Installation of Float Switches
Circle type of float arrangement: (Free Hanging) (Fixed to pipe)
Are float switches hanging free? Y / N
On cable fixed to pipe or rail, free length set at ________ ft.
Check/confirm that influent flow will not tangle floats: Y
Float Switch Location:
Simplex Duplex
Pump off ______ ______ ft. above top of pump
Pump on ______ ______ ft. above off level
Lag pump on ______ ______ ft. above on level
High level alarm ______ ______ ft. above lag pump on
Start-Up Information
Present at
Name Start-Up
Customer Y / N
Contractor Y / N
Consult. Eng. Y / N
Representative Y / N
Started by:
Firm:
Date: Title:
I certify that the equipment has been inspected and is
ready for permanent operation.
Signed: Date:
Control Panel
General condition at start-up
Manufacturer's identification No.
How is it mounted?
Approximate distance from pump ft.
Is there a junction box in pit? Y / N Where?
Electrically connect the pump leads, float switches and
power supply leads per instructions located in the control
panel door.
Does panel include water-sensing relay? Y / N
Make/Model of relay:
Confirm winding thermostat leads were correctly connected
to appropriate relay in control box: Y / N
Confirm wiring was done correctly: Y / N
This report must be submitted to Flowserve Pump Division to
activate warranty.
Mail or Fax to:
Flowserve pump Division
5310 Taneytown Pike
Taneytown MD 21787
Attention: MSX Service Department
Fax 410-756-2615
WARNING: Consult Instruction Manual before performing any start-up functions listed above.
To Next Page
Loading...
