Fluke 831 - Page 10

l
(1) Power key – used to switch the rugged device on.
Press and hold down the power key until the device turns on.
l
(2) Front camera
l
(3) Ambient light sensor
l
(4) Volume down button (refer to Note below)
l
(5)Strap (on either side of the device)
l
(6)Rear camera
l
(7)LEDflash
l
(8)Foldable stand – used to hang device from a railing or lay it down in perfect viewing
position
l
(9)Location of Near Field Communication (NFC) antenna
l
(10)Protective bumper
l
(11)USB type C multipurpose connector – used to charge the rugged device or connect
the tablet to auxiliary equipment such as a PC
l
(12)Magnetic strap – used to hang device on any magnetic surfaces
Note
The only application that runs on this rugged device is Shaft Alignment. The application
runs in only landscape mode. Additional apps cannot be installed in this dedicated
device.
To capture screenshots on the device, press keys 1 and 4 simultaneously.
If the device freezes or is unresponsive, press and hold keys 1 and 4 simultaneously for
more than 7 seconds to restart device.
To turn the rugged device, press and hold down the power key [1]. To operate the device, tap
and swipe the touchscreen.
To turn the device off, press and hold down the power key [1]. Two hints appear on the dis-
play.
10 Version:1.0
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com