Coupling properties
From the dimensions screen, tap coupling to access coupling carousel.
Swipe the carousel [1]up or down and select desired coupling type.
The following coupling types are available for selection:
l
Short flex — These couplings feature fitted transmission elements with play (such as
teeth, claws or bolts) or elastic connecting elements like rubber ‘tires’ or springs.
l
Spacer shaft — When the coupling halves are joined by a spacer element, its length must
be entered.
l
Single plane — The coupling halves are bolted directly together. Loosen the bolts before
taking measurements, since they would otherwise distort the true alignment condition.
l
No coupling — This coupling format is intended for use with CNC machines. In this
format, the length between the two shafts must be entered.
Targets
Targets are misalignment values specified as an offset and an angle in two perpendicular
planes (horizontal and vertical) and used to compensate for dynamic loads.
With coupling carousel shown, tap the item "Targets" to access the coupling targets screen.
Fluke
831 41
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
