Initialize sensor
The hint "Communication error" [1] suggests that the sensor has not been initialized although
the laser beam may have been correctly adjusted.
Tap the detector and sensor area [2] to access the menu item 'Sensor list'.
Tap menu item 'Sensor list' [1] to see scanned sensors, then tap [2] to scan sensors. The
hint 'Scanning for sensor(s)' [3] comes into view.
When the sensor is detected, it is listed down and a blue bold dot [1] is shown next to the
detected sensor.
Tap the listed sensor to initialize. When the sensor is initialized, a bold blue dot [2] is shown.
Fluke 831 55
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
