If the laser beam status is "OK" or "Centered" [1] tap "Set to zero" [2] to set the current laser
dot position as 0,0. The rX,rY values are then monitored to check the stability of the values.
Tap "Absolute" to return to the absolute values.
Note: Shown menu items are used to show these items:
Sensor list – displays serial number of sensors detected or previously used, as well as type of
connection used for communication.
Sensor properties – displays detailed information of the sensor unit in use
54 Version:1.0
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
