1: Quick release lever; 2: Horizontal angle adjustment knob; 3: 90° roof prism; 4: Vertical
position adjustment thumbwheel; 5: Measure mark = center of posts; 6: Support post (not
part of reflector); 7: Reflector dust cap
CAUTION
Avoid vigorous polishing to preserve the anti-reflective coating. Keep the dust cap on
the reflector when it is not in use.
Sensor and reflector labelling
Labels used in communicating laser safety and other general information are to be found
affixed to the housing of the system components.
l
(1) The laser safety warning symbol label is affixed on the front of the sensor.
l
(2) On the back of the sensALIGN 3 sensor is an amalgamation of three labels. The top
label shows the laser safety warning. The lower label contains the sensor identification,
related certification, and disposal information. The round calibration check label shows
the calibration check due date; the black arrow points to the month when the calibration
check is due. The year appears in center of the label.
l
(3) The label affixed on the back of the reflector
16 Version:1.0
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
