Fluke 831 - Open an Asset Measurement Assigned to an RFID Tag

Tap to exit the screen.
Note
If however, data had already been assigned to the RFIDtag, a hint to overwrite the data
is shown.
Open an asset measurement assigned to an RFIDtag
From the home screen, tap
the "RFID" icon.
Position the rugged device such that its built-in NFCantenna is as close to the RFID tag as pos-
sible (less than a centimeter).
Tap to open the asset measurement.
Fluke
831 25
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com