Fluke 831 - Taking Measurement Points Automatically

l
(1) Vertical feet position (bold colored tolerance arrows show direction to move/correct
machine feet)
l
(2) Horizontal feet position (bold colored tolerance arrows show direction to move/-
correct machine feet)
l
(3) Vertical coupling results
l
(4) Horizontal coupling results
l
(5) Selected results mode
l
(6) Alignment condition tolerance icon
l
(7) Used to select Horizontal and Vertical feet and coupling results in 3D / 2D
l
(8) Save asset measurement results
l
(9) Create asset measurement result report
l
(10) Show asset measurement table
l
(11) Tap to start Live Move
Taking measurement points automatically
Measurement points may be taken automatically if the default setting item "Take points auto-
matically after stabilization" has been activated. The item 'Default settings' is found under
"Configuration".
The initial measurement is taken by tapping either the pulsating M or after sta-
bilization.
When the rotational angle of the sensor and reflector is within the sector range, a series of dots
in circular motion (1) indicate the stabilization process. Once this occurs stop the rotation of
the shafts and wait for the pulsating M to appear.
Fluke
831 61
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com