After measurement is taken, the sector is highlighted red. This is an indication of the meas-
urement quality. Rotate shafts to the next sector, then tap the pulsating M to take meas-
urement. Repeat this step for the set active points. The color of the measured sectors shows
the attained measurement quality.
The attained measurement quality is also shown as a percentage.
In this particular example, the number of active points set is 4 and therefore the hint (1) to
take a further measurement point.
Note: Coupling results (2) are displayed because three measurement points are sufficient to
determine the alignment condition.
To view alignment results at this stage, tap .
Tap to cancel measurement.
Note
As shafts are rotated, and depending on the physical condition of the machines, the act-
ive clock sectors change color from red (quality < 40%) to amber (quality >40%<60%)
to green (quality >60%<80%) to blue (quality >80%). Coupling results are displayed
as soon as the measurement quality attains 40% and the minimum 3 measurement
points have been taken (active clock sector turns amber).
Once the set number of active clock measurement points is attained, results are shown.
60 Version:1.0
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
