Tolerances
Alignment quality is evaluated through comparison with tolerances based upon entered
machine dimensions and RPM.
The tolerance ranges are compiled as tables according to type of coupling, coupling format,
and diameter (for the gap value) as well as RPM. When the coupling type is spacer, the tol-
erance table values are determined by the length of the spacer shaft and the RPM.
Tolerances are accessed through the dimensions screen.
Tap the coupling [1]. The coupling carousel is shown.
Swipe the carousel [1]to select the desired coupling type [2] then tap the item "Tolerances"
(3) to access tolerances screen which shows the coupling tolerance table.
Available tolerance tables
The shown tolerance tables are based on machine operating frequency.
Fluke 831 43
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
