Configuration
From the home screen, tap the configuration icon to access these configuration items:
l
"System settings" sets these items:
> Language (system language); > Date; > Time; > Time zone;
> Animation state — regulates the transition between the dimension, measure and res-
ults screens. Options available: fast and standard. If "Animation state" is on, the trans-
ition between screens is set to standard and therefore noticeable. If off, the transition is
fast.
> Auto brightness — adjusts the display brightness of the touch device. If "Auto bright-
ness is on, the display brightness adjusts automatically. If off, then the display bright-
ness is adjusted manually. Drag the brightness slider to the left (decreases brightness)
or right (increases brightness).
> Preferred results view 2D or 3D
> Power options — used to manage the power usage in the touch device. The power
modes available are: "Standard" (the display dims after 10 minutes and goes to sleep
mode after 20 minutes), "Maximum" (no dim and no sleep mode), "Presentation" (the
display dims after 1 hour, but never enters the sleep mode) and "Minimum" (the display
dims after 3 minutes and goes to sleep mode after 5 minutes). To get out of the sleep
mode, press the power key.
l
"Default settings" is used to set units of length, angle and temperature; the default dia-
meter is set here. The item is also used to set the number of Active Clock measurement
points required to obtain results. 3 – 5 points may be set. Although a minimum of 3
measurement points are required for results, it is recommended to take the maximum
number of points available.
Other items set under "Default settings" include: To take points automatically after
18 Version:
1.0
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
