on the round label affixed to the back of the sensor.
The sensor should be returned to an approved technical site for calibration check.
Note
The calibration due date is also found under "Sensor properties".
If the calibration due date has expired, the due date will be highlighted red.
The calibration due date will also appear on the asset measurement report if the "Gen-
erating report" menu item "Alignment measurement components " is activated.
114 Version:1.0
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
