the proceed to select the next element. When all machine train elements have been
defined, tap to return to the screen from where the triple "Train Manager" / "Train
Setup" / "Train Fixation" screen was initially opened.
If TRAINFIXATIONis selected, the machine train fixation screen can be used to fix and unfix
machine feet pairs or entire machine. This solves machine bolt-bound problems.
In this example, the pump has no feet [1] and is permanently fixed. The motor feet pairs [2]
are unfixed and therefore movable. Tap [3] to return to the screen from where the
triple "Train Manager" / "Train Setup" / "Train Fixation" screen was initially opened.
To make a machine permanently fixed tap the symbol [1] at the center of the machine. To
undo this action, tap the symbol [1] again. When a machine is unfixed feet are shown. To fix
any machine feet pair tap the necessary feet pair. Fixed feet pairs are shown marked red [2].
If feet pair are redefined, then machine dimensions must be adjusted. Tap to open the
dimensions screen and enter necessary dimensions.
34 Version:1.0
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
