5-1
Chapter 5
Viewing and Printing Saved Reports
Chapter 5 provides the following information:
• Instructions for sending saved test reports to a serial printer.
• Instructions for viewing, deleting, and renaming test reports saved in the test
tool’s memory.
Printing Test Reports
This section describes how to send reports directly to a printer. If you want to send
reports to a computer, use the CableManager software provided with the test
tool. See the Appendix or the online help in CableManager for instructions.
The PRINT mode on the rotary switch lets you send saved Autotest reports or
report summaries to a serial printer or a PC through the test tool’s EIA-232C serial
port. You can also edit the header, operator name, and site name that appear at the
top of reports.
To Next Page
Loading...
