To Next Page

To Previous Page

DSP-4000 Series

Users Manual

5-6

Viewing, Renaming, and Deleting Test Reports

To view test reports, delete test reports, or rename the cable identification given on

a saved report, proceed as follows:

1. Turn the rotary switch to SPECIAL FUNCTIONS.

2. Press E to select View/Delete Test Reports. The

VIEW/DELETE TEST REPORTS screen appears showing the first screen of

test report labels. The reports are listed in the order saved, starting with the

oldest report in memory. Each test report label shows the date and time the

report was saved, the cable identification name, and an overall test result (pass,

fail, or warning).

3. Use # Page Up, $ Page Down, and D U to highlight the report

you want to view, rename, or delete.

4. Press the softkey labeled with the function you want. The softkeys function as

follows:

• ! Delete Report: Deletes the highlighted report from memory.

• @ View Result: Displays the overall Autotest result and

headroom value for the highlighted report. To see detailed results for a

test, press View Result again; then highlight the desired test and

press E.

To change the cable identification, press the @ Rename Report

softkey that appears after you press View Result twice. Use the

softkeys to edit the cable identification. Press S when you are done.

To delete all of the Autotest reports stored in memory, select Delete All

Test Reports from the main SPECIAL FUNCTIONS menu.

Fluke CableAnalyzer DSP-4000 Series User Manual

Other manuals for Fluke CableAnalyzer DSP-4000 Series