EasyManuals Logo

Fluke CableAnalyzer DSP-4000 Series User Manual

Fluke CableAnalyzer DSP-4000 Series
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
DSP-4000 Series
Users Manual
2-14
Using the Talk Mode
The Talk mode allows two-way voice communication over twisted pair or fiber
cable (Fiber Test Adapters are required for fiber cable). Two-way communication
over twisted pair cable requires two good wire pairs.
Note
The Talk mode is disabled during cable tests. The Monitor jack on
the optional DSP-LIA013 does not support the Talk mode.
Use the Talk mode as follows:
1. Connect the main and remote units to the cable under test.
2. Plug the headsets into the headset jacks on the main and remote units.
3. Press V on either the main or remote unit; then speak into the headset’s
microphone. To adjust the volume at the main unit, use U or D. To adjust
the volume at the remote, use V to cycle through the volume settings.
4. To exit the Talk mode, press e or turn the rotary switch to a new position.
The Talk mode turns off automatically when you start a cable test.

Table of Contents

Other manuals for Fluke CableAnalyzer DSP-4000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fluke CableAnalyzer DSP-4000 Series and is the answer not in the manual?

Fluke CableAnalyzer DSP-4000 Series Specifications

General IconGeneral
BrandFluke
ModelCableAnalyzer DSP-4000 Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals