B-1
Appendix B
Getting Started with CableManager
Software
Introduction
CableManager software is a Windows
program that lets you do the following:
• Transfer saved Autotest reports and report summaries from the test tool or the
memory card reader to a PC.
• Sort and edit Autotest reports.
• Customize the appearance of printed reports and summaries.
• Add plots to printed test reports (DSP-4100)
• Transfer SETUP settings to and from the test tool.
• Update the software in the test tool and remote.
The minimum requirements are a 200 MHz Pentium
microprocessor system with
64 MB of RAM, Windows 95, 98, or NT/2000 software, and a monitor with 800 x
600 resolution.
Notes
The CableManager features described in this manual may vary,
depending on the version of CableManager you received.
CableManager upgrades and documentation on new features are
available on the Fluke Networks website at
www.flukenetworks.com.
The instructions in this manual assume that you have already
installed and know how to use Microsoft Windows
95, 98, or
NT/2000.
To Next Page
Loading...
Need help?
General
