DSP-4000 Series
Users Manual
2-26
Monitor
The MONITOR mode lets you continuously monitor impulse noise on twisted pair
network cables. With the optional DSP-LIA013 link interface adapter, you can
monitor network activity on Ethernet systems. Network activity is monitored for
collisions, jabber, and percentage of system utilization. The traffic adapter also
includes a hub port locator, which helps you determine port connections at a hub,
and a hub port capabilities feature that determines the standards supported by a
port.
Setup
Allows you to do the following:
• Select a test standard and cable type.
• Edit the report identification that appears on saved Autotests.
• Set the cable ID to increment automatically each time you save Autotest
results.
• On DSP-4100 test tools, you can set the test tool to save attenuation, return
loss, NEXT, and FEXT plots as part of Autotest reports when those tests are
required by the selected test standard.
• Set the backlight timer to turn off the backlight after a specified period of
inactivity.
• Set the power-down timer to switch the test tool to a low-power mode after a
specified period of inactivity.
• Select interface parameters for the serial port.
• Set the date and time.
• Select a format for the date and time.
• Select a unit for length measurements.
• Select a format for displaying decimal fractions.
• Select a language for the display and printed reports.
To Next Page
Loading...
Need help?
General
