Getting Started
Rotary Switch
2
2-27
• Select a frequency for the power line noise filter.
• Set the fault threshold for the impulse noise test.
• Enable or disable the test tool’s beeper.
• Modify test standards for custom test configurations.
• Select a remote end configuration when a Fiber Test Adapter is attached.
Print
Allows you to send saved reports or report summaries to a serial printer. You can
print the results from previously stored Autotests. Also lets you edit the report
identification information and select a format for Autotest reports sent directly to a
printer.
Special Functions
Allows you to do the following:
• View or delete test reports saved in memory.
• Change the cable identification assigned to a saved Autotest report.
• Generate a tone to use with an inductive pickup device, such as the Fluke
Networks 140 A-Bug Tone Probe, to identify cable runs.
• Determine the cable NVP to ensure maximum accuracy of length and
resistance results.
• View the status of the NiMH battery in the main unit or remote.
• Check the status of the LIA attached to the main or remote unit.
• Perform a self-calibration on the test tool and remote.
• Run a self-test to verify proper operation of the test tool, link interface adapter,
and remote.
• On a DSP-4100 test tool, you can view the status of the memory card and
format the card.
• View version information for the main and remote units.
To Next Page
Loading...
Need help?
General
